Shimano FH-RS505 135mm Rear hub
| Hub Data | ||
|---|---|---|
| Manufacturer | Shimano | |
| Model | FH-RS505 | |
| Descriptor | ||
| Position | Rear | |
| Axle Type | 10mm | |
| OLN | 135 mm | |
| Spoke Interface Type | J-Bend | |
| Brake Compatibility | disc, Centerlock | |
| Drive Interface | Shimano 11 road (36.75mm) | |
| Internal Gearing | none | |
| Dynamo Type | none | |
| Spoke Hole Diameter | 2.6 mm | |
| Left Flange Diameter | 44 mm | |
| Right Flange Diameter | 45 mm | |
| Left Flange Offset | 34 mm | |
| Right Flange Offset | 17.5 mm | |
| Mid-Flange Offset | -8.3 mm (to the left) | |
| Weight | 378 g | |
| URL | https://bike.shimano.com/en-EU/product/c... | |
| Metadata | ||
|---|---|---|
| Hub ID | 488 | |
| Record Status | Public - attention required | |
| Created | May 18, 2019 5:18am | |
| Contributed By | Tim W | |
PLEASE NOTE: Shimano publishes hub dimensions in a relatively confusing manner on bike.shimano.com. They seem to provide the outside-to-outside flange spacing, and an overall offset of the flanges as a whole. Wheelbuilders are interested in the distance from the midpoint between locknut faces to the middle of the flange (not the inside or outside face). When necessary, I convert Shimano's data into useful spoke calculation dimensions with some simple arithmetic, and factor in 3mm thick hub flanges (an approximation). The formula is to divide spacing by two, add or subtract the overall offset, then subtract half of our assumed 3mm flange thickness. Please check the notes to see if the values for this part are derived from Shimano's published data or actual measurements of a hub specimen. -Karl
Skewer weight 68g. 32 hole model weighed and measured, two samples were identical in weight.
Non series Tiagra level. Model is discontinued, Shimano road disc hubs are going to be 142x12 thru axle going forward.
Non series Tiagra level. Model is discontinued, Shimano road disc hubs are going to be 142x12 thru axle going forward.